Hanna Instruments Edge - Page 48

Operational Guide
48
Parameter Description Choices Default Basic mode
T.Coef. (%/ºC) This parameter
is related to the
solution being
measured at
temperatures
other than 20
or 25 ºC. It is
used to correct
measured
conductivity
to a reference
temperature by
applying a xed
factor for linear
compensation
0.0 to 6.00 (%/
ºC) Note: Setting
to 0.00 is the
same as using
No TC.
1.90 (%/ºC)
Close for natural
waters or salt
solutions.
Not available.
Automatically
set to 1.90%/ºC.
T.Ref. (ºC) The user may
select either
20ºC or 25ºC
reference
temperature for
temperature
corrected
conductivity.
20 ºC or 25 ºC 25 ºC Available
TDS Conversion
Factor.
This factor
is used to
mathematically
convert
conductivity to a
TDS value.
0.40 to 0.80 0.50 Available
VIEW T.Ref. or
T.Coef.
The user may
choose whether
to display the
reference
temperature
(T.Ref) or the
Temperature
coecient on the
display with the
measurement.
T.Ref (ºC) or T.
Coef. (%/ºC)
T.Ref (ºC) T.Ref (ºC)
automatically
displayed during
measurement.
EC Meter
Conguration