19
19
TURBIDITY MEASUREMENT
7. TURBIDITY MEASUREMENT
Note: For wine analysis it is recommended to always work with the AVG mode on.
• Press ON/OFF to turn the instrument on.
• When the LCD displays “----”, the instrument is ready for measurement. The current time appears
on the secondary LCD, if selected in Setup menu.
• Fill a clean, dry cuvette with 10 mL of wine up to the mark, taking care to handle the cuvette by
the top. Replace the cap.
Note: To remove any fingerprints or dirt, wipe the cuvette thoroughly with a lint-free cloth. If
necessary, apply HI93703-58 Silicone oil (see General tips for an accurate measurements),
recommanded only if low turbidity values need to be read.
• Insert the cuvette into the instrument and close the lid.
To Next Page
Loading...
