General Settings 80
Stop Bits
Option: 1, 2
This option allows the user to set stop bit option based on the stop bit of the connected device.
• With Stop Bits selected, press Modify for the drop‑down list to display.
• Use the
ud keys to navigate between options.
• Press Select to save.
RemLink_Timeout
Option: 10 to 1200 s
This option allows the user to enter the number of seconds that a remotely connected device should wait for an
acknowledgement (for a command) before timing out.
• With item selected, press Set to modify.
• Press the
ud keys to increase or decrease the value (keep the key pressed to fast‑forward).
• Press CFM to save.
RemEdit_Timeout
Option: 10 to 1200 s
This option allows the user to enter the number of seconds that a remotely connected device should wait before
exiting Edit mode.
• With item selected, press Set to modify.
• Press the
ud keys to increase or decrease the value (keep the key pressed to fast‑forward).
• Press CFM to save.
To Next Page
Loading...
