Measurement Setup Overview
Calibration, Reading, Temperature, View, Alarms, Logging, Profile tabs help user navigate through all
measurement operations. The following table presents an overview of possible functions.
Calibration
Conductivity Resistivity TDS
Salinity
% ppt, PSU
Last Calibration
Calibrate
Clear
Based on
conductivity or
salinity calibration
Based on
conductivity
calibration
Calibrate
Clear
Based on
conductivity
Standard Entry Type Automatic, Manual
Calibration Reminder
Disabled
Daily
Periodic
– –
Disabled
Daily
Periodic
–
Cell Constant
0.0500 to
200.0000
– – –
Calibration Points
Single Point
Multiple Points
– – –
Reading
Conductivity Resistivity TDS Salinity
Unit
Salinity Scale
μS/cm
mS/cm
AutoRanging
Ω•cm
kΩ•cm
mΩ•cm
AutoRanging
ppm
ppt
AutoRanging
ppt
PSU
%
TDS Factor – – 0.40 to 1.00 –
Stability Criteria Accurate, Medium, Fast
Reading Mode
Direct
Direct/Autohold
Probe Type Probe code
Temperature
Conductivity Resistivity TDS Salinity
Temperature Source Automatic, Manual
Temperature Unit °C, °F, K
Temperature
Compensation
Linear, Natural, Standard, Disabled
Manual ‑20.0 °C to 120.0 °C
Reference Temperature
5.0 °C to 30.0 °C
(when temperature compensation option is not disabled)
Temperature Coefficient
0.00 to 10.00 %/°C
(with Linear temperature compensation option only)
User Temperature
Calibration
Calibrate
Clear
System Menu Items 28
To Next Page
Loading...
Need help?
General
