Table
When Table is selected, the measured values are displayed tabulated (complete with date, time, and notes
made during logging). The newest data is displayed at the top of the table.
9.5. ALARMS
Options: High /Low configured parameter value, High/Low Temperature
Users can set the threshold limits for the measured parameters. When the measurement exceeds set high‑threshold
value or drops below set low‑threshold value, the alarm is triggered and an alarm message is displayed.
If the Alarm Beeper is enabled (See: System Menu Items / System Settings / Alarm Beeper), an audible beep
will be heard.
Note: High-parameter values cannot be lower than low-parameter ones.
To set an alarm limit:
1. Tap
to enable low or high parameter threshold option.
2. Use the on‑screen keypad to enter the value.
3. Tap Enter to confirm (Cancel to exit and return to measurement settings).
45 Measurement & Probe Setup Menu
To Next Page
Loading...
Need help?
General
