22
GENERAL OPERATIONS
The probe status screen identifies the probe and attached sensors. See section 6.4. TUTORIAL for
information on the Tutorial mode.
Press Measure to view the measurement screen.
Press Param. to open the Parameters menu. This screen can also be accessed from the main menu.
Press the down arrow key to view additional information about the probe.
6.4. TUTORIAL
If the tutorial is enabled, after the initialization has been completed, the Tutorial screen is displayed.
Press ESC to view the Probe Status screen and skip the tutorial.
Press Next to start the tutorial. The following tutorials are available: Sensor Preparation, Sensor
Maintenance, and Sensor Installation.
Press Select to view the selected tutorial.
6.5. BASIC OPERATIONS
The main operating modes are setup, measurement and logging.
The instrument can be configured to display measurement data for all enabled parameters (up to 12).
Press the arrow keys to scroll between measured data in all available parameters.
The display has a feature that automatically sizes the digits to fit the screen. With one measurement
the digits will be largest.
Press the keys on the alphanumeric keypad (1 - 7) to select number of parameters displayed at one time.
Note: pressing 7 will display up to 12 parameters simultaneously.
To Next Page
Loading...
