APEX™ Exciter Incorporating FLO™ Technology
Details of the System Setup Screens Navigating the LCD Display Screens
2604s300.fm
03/08/07 888-2604-001 Page: 3-39
WARNING: Disconnect primary power prior to servicing.
Up to four Existing RTAC correction setups can be saved as RTAC filter sets. An option
to name each saved filter setup exists. Filter setups can be stored for many reasons, such as
when the transmitter was first installed, after transmitter maintenance, and etc. They are
good for comparative testing.
• Filter Set: (selections include 1 through 4)
• Filter Title: Brings up an alpha/numeric touch keypad to enter the name for the select-
ed filter set.
• Save: Pressing this soft key saves the current RTAC correction algorithm to the filter
set selected.
The filter set should be given a name (in the filter title selection).
• Restore: Pressing this soft key applies the selected, pre-saved correction algorithm fil-
ter set to the RTAC correction algorithm.
This causes the Main screen RTAC samples to be set to Default, which applies the
pre-saved filter set to the RTAC correction algorithm.
To Next Page
Loading...
Need help?
General
