1
Copyright © 2010, Harris Corporation
1
Introduction
The DA-6804+D series of distribution amplifiers is designed to distribute serial
digital signals according to SMPTE259C, 292M, 424M and DVB-ASI standards.
The individual modules are available as follows:
DA-DHR6804+D is a dual channel 3 Gb/s HD/SD-SDI distribution amplifier
with reclocking. See page 3 for a list of its main features.
DA-DH6804+D is a dual channel 3 Gb/s HD/SD-SDI distribution amplifier. See
page 4 for a list of its main features.
DA-DSR6804+D is a dual channel SD-SDI distribution amplifier with
reclocking. See page 5 for a list of its main features.
DA-DS6804+D is a dual channel SD-SDI distribution amplifier. See page 7 for a
list of its main features.
DA-HRO6804+D is a 3 Gb/s HD/SD-SDI single channel optical to electrical and
electrical to optical converting distribution amplifier. See page 8 for a list of its
main features.
DA-DHROE6804+D is a 3 Gb/s HD/SD-SDI dual channel optical to electrical
converting distribution amplifier. See page 9 for a list of its main features.
DA-DHREO6804+D is a 3 Gb/s HD/SD-SDI dual channel electrical to optical
converting distribution amplifier. See page 10 for a list of its main features.
DA-DHROO6804+D is a 3 Gb/s HD/SD-SDI dual channel optical distribution
amplifier with dual electrical outputs. See page 12 for a list of its main
features.
Each distribution amplifier consists of a front module and a back module, and
operates in FR6802+ series frames.
Each distribution amplifier, with its corresponding back module, occupies two slots
in the frame. Ten distribution amplifiers can be loaded in a frame.
Each distribution amplifier contains two inputs and eight outputs, and can be
configured as a single channel (1×8_ACO or 1×8) or two independent channels
(2_1×4). Each FR6802+ frame can provide up to 20 channels for serial digital
signal distribution.
The DA-6804+D series is featured as “green” (power saving). The power can be
shut down automatically if no input signal is detected. Power consumption should
be reduced if any output BNC is not terminated.
To Next Page
Loading...
