DA-6804+D Series
Installation and Operation Manual
47
Copyright © 2010, Harris Corporation
Changing
Parameter
Settings
You can change module parameter settings locally with the card-edge jumpers as
described in Setting Locally Controlled Parameters on page 34.
You can change module parameter settings remotely via CCS software. See your
CCS control software application installation and operation manual for instructions
on how to change parameter settings.
Recalling Default
Parameter
Settings
You cannot recall default parameter settings for these modules.
Reading the
Software and
Hardware
Versions
The current software version of these modules can only be viewed using a
CCS-enabled control panel or a CCS software application. See the appropriate
control panel installation and operation manual, CCS software application user
manual, or CCS software application online help for information on viewing
software and hardware version numbers.
To Next Page
Loading...
