DA-6804+D Series
Installation and Operation Manual
23
Copyright © 2010, Harris Corporation
Setting Up J3
Jumpers
The J3 jumper controls the control modes available for DA-6804+D series modules.
Local control for channel configuration
Remote control enable
Table 2-3 J3 Jumper Settings
Jumper
Selection
Pin
Setting
Label Description
J3 1/2 1×8_ACO Locally configures distribution
amplifier as single channel (1×8) with
ACO
J3 3/4 1×8_IN1 Locally configures distribution
amplifier as single channel (1×8);
input is from IN1
J3 5/6 1×8_IN2 Locally configures distribution
amplifier as single channel (1×8);
input is from IN2
J3 7/8 2_1×4 Locally configures distribution
amplifier as dual channel (2-1×4)
J3 11/12 REMOTE Enables remote control via CCS; J3
pins 1-8 are not functional
To Next Page
Loading...
