24 NUCLEUS Installation and Operation Manual
Chapter 2: Operation
Follow these steps to configure alarms for a selected device:
1. In the NUCLEUS display, navigate to the device for which you
want to configure alarms.
2. Select the device, and then press the Option button.
Figure 2-8. Configure Alarms
3. Select Configure Alarms from the Options menu, and then press
Enter.
4. Press Enter again to confirm the IP address of the device.
A list of the possible alarms on the selected device appears.
5. From the list of alarms, select the alarm that you want to configure,
and then press Enter.
The alarm settings information appears.
Figure 2-9. Alarm Settings Information
6. To change an alarm setting, select it from the list, press Enter, and
then use an adjustment knob to make the appropriate changes.
7. Press the Exit button to go back the alarm settings list or to
navigate back to the Options menu.
To Next Page
Loading...
Need help?
General
