40 NUCLEUS Installation and Operation Manual
Appendix A: Control Panel Setup Parameters
Setup Parameter Descriptions
Scroll Mode
In Wrap mode, when you scroll through a parameter list, the control
panel considers the list as a circular set of data. When the last parameter
in the list is reached, the first parameter in the list immediately follows
it. In Don’t Wrap mode, the control panel stops when the last parameter
in the list is displayed. To return to the first parameter, you must scroll
through the entire list in the opposite direction.
Screen Intensity
To accommodate different equipment room lighting conditions, you can
set the panel display intensity. Use the numeric parameter sliding bar to
make the intensity adjustments.
LED Intensity
Using a numeric parameter sliding bar, you can adjust the intensity of
the LEDs on the preset buttons.
LCD Intensity
Using a numeric parameter sliding bar, you can adjust the intensity of
the user-programmable LCD buttons.
LCD Contrast
Using a numeric parameter sliding bar, you can adjust the contrast of
the user-programmable LCD buttons.
Screen Saver Timeout
To extend the life of the display device, the screen saver automatically
shuts off the display after a preset period of inactivity. Using the screen
saver timeout parameter, you can set the duration of inactivity after
which the control panel display turns off. The available options are Off,
5, 10, 20, or 30 minutes. If the Off feature has been enabled, the screen
saver will not operate.
To exit the screen saver mode, press any button. No parameters will be
changed when you exit the screen saver mode.
To Next Page
Loading...
Need help?
General
