NUCLEUS Installation and Operation Manual 41
Appendix A: Control Panel Setup Parameters
Screen Saver Select
Using this parameter, you can select either a blank screen or a default
screen to display when the control panel’s screen saver is activated.
Shaft Direction
Using this parameter, you can determine whether the clockwise rotation
of the adjustment knobs moves up or down through a parameter list, and
increases or decreases numeric values when adjusting numeric values.
Leitch Name Mode
With this parameter enabled, device parameter names are displayed in
the control panel screen as Leitch default names. Otherwise, alias
parameter names are displayed. For information about parameter
aliases, see your CCS software application user guide.
TRAX
With this parameter enabled, you can use the NUCLEUS-TRAX on the
control panel. For more information about NUCLEUS-TRAX, see your
NUCLEUS for Processing Device Control User Manual.
TRAX Confirm
With this parameter enabled, you receive a message after you press
TAKE, asking whether or not you want Trax to jump to the device
menu associated to the selected source. For more information about the
TRAX Confirm feature, see your NUCLEUS for Processing Device
Control User Manual.
Panel Name
This parameter establishes a user-specific name for the control panel.
This name identifies the control panel throughout the network. For
example, when the control panel tracking parameter is enabled (see
“Control Panel Tracking” on page 42) the control panel is tracked by
other panels using this name.