NUCLEUS Installation and Operation Manual 27
Chapter 2: Operation
Transferring Configurations with a USB
Memory Key
Using the File Manager menu, you can copy configurations, software,
and panel settings between NUCLEUS and a Universal Serial Bus
(USB) memory key. You can also use the File Manager menu to delete
configurations from a USB memory key and from NUCLEUS itself. To
access the File Manager menu, press the Option button, and then
select File Manager from the list.
To copy or delete NUCLEUS configurations, users must have been
granted access to do so. For information about copy and delete
access, see “Setting Control Panel Options” in your NUCLEUS
control option manual.
Table 2-4 describes each menu item.
Table 2-4. File Manager Menu
Menu Name Menu Description
Copy All Configs to USB Copies all configurations from NUCLEUS to
the USB drive. If the Nucleus/panel name
structure does not exist on the USB drive,
NUCLEUS creates it when the files are
transferred to the drive.
Copy One Config to USB Copies a selected configuration from a list on
the NUCLEUS panel to the USB drive
Copy Settings to USB Copies the panel’s set up parameters to the USB
drive
Copy Firmware to USB Copies the firmware currently installed on the
panel to the USB drive
Copy Everything to USB Copies all the
NUCLEUS configurations, the
firmware currently installed on the panel, and
the panel’s set up parameters
from NUCLEUS
to the USB drive
Delete Config from USB Deletes a selected configuration file from the
USB drive. In the list, configurations are
identified by control panel name/configuration
name (for example panel3/news2).
To Next Page
Loading...
Need help?
General
