28 NUCLEUS Installation and Operation Manual
Chapter 2: Operation
Delete Firmware from
USB
Deletes a selected firmware file from the USB
drive. When you select this option, you first
chose a panel name followed by the firmware
file.
Copy All Configs to Panel Copies a maximum of five configurations from
the USB key to NUCLEUS. If there are
configurations on the panel, you may need to
delete one or more of them before completing
the copy operation.
Copy One Config to Panel Copies a selected configuration from the
available configurations on the USB key to
NUCLEUS. In the list, configurations are
identified by control panel name/configuration
name (for example panel3/news2).
Copy Settings to Panel Copies NUCLEUS set up parameters to the
control panel. In the list, setup files are
identified by control panel name. For
information about NUCLEUS set up
parameters, see “Appendix A: Control Panel
Setup Parameters” on page 37.
Copy Firmware to panel Copies a selected firmware file from the USB
key to NUCLEUS. In the list, firmware files are
identified by control panel name.
Undo Copy Firmware to
Panel
Reverts back to the firmware version that was
on the panel before the Copy to Firmware to
Panel command was executed
Delete configuration from
Panel
Deletes a selected configuration from
NUCLEUS. This is a useful operation if you
need to space for other configurations.
Table 2-4. File Manager Menu (Continued)
Menu Name Menu Description
To Next Page
Loading...
Need help?
General
