30 NUCLEUS Installation and Operation Manual
Chapter 2: Operation
• Settings files are identified by panel name.
• Firmware files are identified by panel name.
If the Nucleus/panel name structure does not exist on the USB drive,
NUCLEUS creates it when the files are transferred to the drive.
When you transfer files from the USB key to NUCLEUS, the files you
select are identified in the following ways:
• Configuration files are identified by panel name/configuration
name (for example, panel3/news2).
• Settings files are identified by panel name
• Firmware files are identified by panel name.
Rebooting NUCLEUS
If any of the configurations you transfer to NUCLEUS include routing
panels, you must reboot the control panel before using the
configuration. To reboot NUCLEUS, follow these steps:
1. On the control panel, press the Option button.
2. From the Options menu, select Setup.
3. From the Setup menu, select Reboot.
To Next Page
Loading...