Haulotte HA26 RTJ PRO SW - Page 107

A
B
C
D
E
F
G
H
I
107 4000662720 E 06.17 USA / EN
C - Study of the electric schematics
HA26 RTJ O - HA26 RTJ O SW - HA26 RTJ PRO - HA26 RTJ PRO SW - HA80 RTJ O - HA80 RTJ PRO
REQUIREMENTS DEFINITION
JMV03
CUT-OFF U D FAILURE CUT-OFF CONDITIONS
6 Failure
1 1 1 KMP failure
2 1 1 Jib valve active failure and engine is running
3 1 1 LS valve active failure and engine is running
411
Load management system not calibrated and
machine unfolded and not overriding control
box
511
Load gauges out of range and machine
unfolded and not overriding control box
611
Load gauges incoherence and machine
unfolded and not overriding control box
711
Low power on load gauges out of range and
machine unfolded and not overriding control
box
811
Load management sensors electrical failure
and machine unfolded and not overriding
control box
911
Load management sensors logical failure (
IC=1 or IC=4) and machine unfolded and not
overriding control box
10 1 1 Can failure
REQUIREMENTS DEFINITION
JMV03
CUT-OFF U D SPECIFIC CUT-OFF CONDITIONS
7 Specific
1N/A1
Strain gauges, SP800 estimated weight is
under -40kg and upper controls are activated
(to prevent damages on platform) without load
management system failure
2N/A1
Strain gauges, SP801 estimated weight is
under -40kg and upper controls are activated
(to prevent damages on platform) without load
management system failure
3N/A1
Vibrating wires, estimated weight is under -40kg
and upper controls are activated (to prevent
damages on platform) without load management
system failure
4 1 N/A ASB active for jib raise from upper controls
5 N/A 1 ASB active for jib descent from upper controls
61N/A
Extreme ambient temperature is detected and
machine is unfolded
711
Drive motion active and steering set point is
active (priority to steering while driving), except
for Australia country (steering and jib
simultaneous movements)
811
Delay after steering movement or platform
rotation or platform level movement
9 1 1 Delay after opposite direction jib movement