Chapter XI. Cylinder block
(a) Replace the removed crankshaft rear oil seal with a new one;
shown in the figure;
(a) Remove 8 bolts in sequence, starting with the 8th as
3. Remove the sealant from the cylinder block, the mating
surface of the crankshaft rear oil seal, the flywheel bolts,
and the threaded holes of the flywheel bolts.
(b) Apply a flat-face sealant to the crankcase rear oil seal cover
1. Remove the flywheel from the back of the crankshaft
(b) To remove the rear oil seal cover, insert between the block
(a) Remove any remaining sealant from the cylinder block with
(a) Fix the flywheel with special tools.
clod of cylinders and rear oil seal removal spatula
flat scraper;
(b) Completely clean the mating surfaces of the cylinder block
and seal of oil/grease.
bleeding;
oils.
Note:
the same shaft as shown in the figure;
Note:
ÿ Do not bend or damage the surface to which the sealant
is to be applied.
ÿ Sealant bead diameter: 2-3mm
(b) Loosen and remove the flywheel mounting bolt.
ÿ Recommended to use Loctite sealant
5900H
Note:
ÿ After removing the crankshaft rear oil seal,
ÿ Removed flywheel bolt must be replaced.
replace.
4. Install a new crankshaft rear oil seal
2. Remove the crankshaft rear oil seal cover
95
Examination:
Installation
Disassembly
Machine Translated by Google
To Next Page
Loading...