4C20 Gasoline Engine Repair Manual
dachas
(c) Apply sealant to the places indicated in the figure.
Advice:
ÿ Before installation, use a rag to remove any remaining
(a) Check that the guide bush (A) of the spacer plate on the cylinder block is
not damaged and is
Advice:
engine oil from the crankshaft.
in proper position;
ÿ The width of the sealant bead must not exceed the specified value.
Otherwise, excess sealant will get into the oil pan, which will lead to
clogging of the oil receiver screen.
(b) During installation, do not touch the working edge
(b) Install the spacer plate on the cover (B) of the rear c/shaft oil seal and
insert the pin into the guide bushing
ku.
ÿ Installation must be completed within five minutes.
gland:
7. Install flywheel
ÿ Stage 1. Tightening torque: 60±2 N•m.
(1) Tighten the crankshaft bottom oil seal cover bolts sequentially,
starting with the 1st bolt, in the sequence shown in the figure.
Observe the tightening torque.
(a) Replace the flywheel bolts with new ones;
ÿ Step 2. Turn the key another 90°.
chickpeas from the moment the sealant was applied.
(b) Tighten the flywheel mounting bolts to the specified
ÿ Wait 30 minutes after assembly and before adding engine oil for the sealant
to cure.
ÿ Tightening torque: 10±1 Nm
5. Install the crankshaft rear oil seal
6. Install the transfer box spacer plate.
sequence in the figure.
(a) The rear crankshaft oil seal cover has two holes (indicated by arrows) for
the dowel pins.
96
Machine Translated by Google
To Next Page
Loading...