4C20 Gasoline Engine Repair Manual
(b) Remove the turbocharger
(a) Loosen the 5 nuts (1-5) in the order shown in the figure and
remove the exhaust manifold.
2. Removing the exhaust manifold
Attention:
Note:
masonry.
4. Removing the exhaust manifold gasket
ÿ Once removed, the nuts must be replaced.
ÿ Perform disassembly of the system until the components have completely cooled down.
Note:
ÿ After removal, the exhaust manifold gasket must be
replacement.
Nentov is prohibited!
3. Removing the pressure blocks of the exhaust manifold
(a) Loosen the 4 nuts (1-4) in the order shown in the figure and
remove the two exhaust manifold clamp blocks.
1. Removing the exhaust manifold heat shield
ÿ Cover the resulting opening in the motor to prevent foreign
objects from entering.
(a) Remove the 3 bolts and remove the heat shield you
Clue:
start manifold.
ÿ Once removed, the nuts must be replaced.
ÿ Before removing the exhaust manifold, check the quality of the
exhaust manifold seal and
28
Disassembly
Machine Translated by Google
To Next Page
Loading...