Engine oil change
Chapter IX. Lubrication system
49
4. Installing the engine oil pressure sensor
ÿ Do not perform this procedure until the engine has cooled down
to room temperature (35-40 minutes)! Risk of burns!
Attention:
6. Engine oil drain
(a) Apply Loctite 243 anaerobic thread locker or equivalent to 2-3
threads of the engine oil pressure sensor.
7. Changing the oil filter
(a) Clean the mounting surface of the brackets on the oil filter.
(a) Remove the oil filter and wait 1 minute.
(b) Install the engine oil pressure sensor on the qi block
(b) Apply a small amount of engine oil (no more than 2 ml) to the
O-ring of the new oil filter to improve sealing.
(c) Tighten the oil filter slowly with a wrench
lindrow and wrap.
(b) Remove the drain plug with gasket and drain
those motor oil.
ÿ Tightening torque: 15±1 Nm.
for oil filter (14/76).
ÿ Tightening torque: 20±2 Nm.
Note:
5. Check engine oil leakage
(a) Start the engine and check for engine oil leakage. If a leak is
found, eliminate its cause.
ÿ After removing the drain plug gasket near
living replacement.
Pad
Machine Translated by Google
To Next Page
Loading...