O-ring
4C20 Gasoline Engine Repair Manual
(c) Ensure that the guide pin (A) is present.
(b) Apply sealant to the top flange of the oil
chickpeas after applying the sealant.
(d) Install the upper part of the oil pan within 3 minutes
pallet
(e) Tighten the 13 bolts in the order shown in the figure within
(c) Install the oil pump on top of the oil pan and secure with 3 bolts (A and B).
ÿ Tightening torque: 22±2 Nm.
15 minutes.
(1) Carefully apply sealant to the indicated connection
points of the upper oil pan and cylinder block. The
thickness of the sealant layer is 2-3 mm.
11. Installing the oil receiver
(a) Check that the sealing ring is installed correctly
oil receiver.
ÿ Use 5900H Loctite
ÿ Tightening torque: 22±2 Nm.
ÿ Tightening torque: 10±1 Nm.
10. Oil pump installation
Clue:
(b) Apply a small amount of engine oil to the seal
thread ring.
ÿ Use only original sealant or
(a) Before installation, check the 2 mounting holes (A) to ensure that the oil
log.
pump
(c) Install the oil receiver on the oil pump and secure with 2 bolts.
(b) Fill with at least 5 ml of engine oil to ensure that the oil pump rotor rotates
freely.
54
Machine Translated by Google
To Next Page
Loading...