HBC-Radiomatic technos A - System Information and Diagnostics

14 / 34
Warnings
In the menu item Warnings, warnings and error notifications are shown.
If a warning is triggered, a yellow warning triangle is shown in the upper edge of the display and an acoustic
signal sounds.
To access the warnings and error notifications:
You are in the HBC menu.
1. Navigate to the submenu Warnings and select it.
Current warnings and error notifications are shown here.
2. Browse through notifications by turning the radiomatic
®
iCON.
Exit the submenu Warnings with the Softkey .
To dismiss warnings and error notifications:
x Press the Start button for 2 seconds. The indication in the display disappears and the acoustic signal
stops.
Note:
The cause / error underlying the error notification must be removed.
Depending on the severity of the error, the safety circuits
Si 1 and Si 2
may be blocked and the
functioning of the transmitter is de-activated.
Information
Diverse system information are shown in this submenu.
To access the submenu Information:
You are in the HBC menu.
x Navigate to the submenu Information and select it.
Exit the submenu Information with the Softkey .
Service address
To access the menu item Service address:
You are in the HBC menu.
1. Navigate to the submenu Information and select it.
2. Navigate to the menu item Service Address and select it.
The phone number and Email address of the HBC-radiomatic service hotline or a service partner are
shown.
Exit the menu item Service Address with the Softkey .
Working hours
To access the menu item Working hours:
You are in the HBC menu.
1. Navigate to the submenu Information and select it.
2. Navigate to the menu item Working hours and select it.
The current total hours of operation are shown.
Exit the menu item Working hours with the Softkey .