HBC-Radiomatic technos A - Operation; Activating the Transmitter

8 / 34
Operation
The transmitter is equipped with an electronic radiomatic
®
iLOG key. radiomatic
®
iLOG contains all the
data required for operating the transmitter. Operation is not possible without radiomatic
®
iLOG!
Depending on the version the radiomatic
®
iLOG can also be used for operation of replacement transmitters
of identical construction.
When activating the transmitter and if the radio connection is interrupted (e.g. if the connection is lost or
the transmission range is exceeded), the transmitter reacts with the so-called enforced zero-position.
Release all operating elements so they can return to the zero-position and actuate the start button. The
machine will not react if the operating elements are not in zero-position. This prevents uncontrolled
machine movements after the radio connection has been interrupted.
Activating the Transmitter
With start sequence
1. Insert a charged battery into the battery compartment.
2. Turn the STOP switch to unlock. The display shows Enter start sequence.
3. Shortly press the start button and then release. The transmitter will switch off if the button is pressed
for longer than half a second!
4. Press the start button again until the display shows the customized start screen and the status
indication blinks green. Then release the button. The transmitter is now ready for operation.
5. Depending on the application, you must press the start button again before movement commands
can be carried out.
Note:
The transmitter switches off if
x
the start button is pressed for longer than half a second in step 3 of the start sequence.
x
the start sequence (steps 3 and 4) takes over 5 seconds.
x
another button is pressed during the start sequence.
You must then repeat steps 3 and 4 or 3 to 5.
Caution:
Before starting work always trigger the acoustic signal. This warns all colleagues that the machine
is about to move.