HBC-Radiomatic technos A - Connectivity and General Settings

17 / 34
Connections
The display configuration and the RF interface can be configured in this submenu.
To access the submenu Connections:
You are in the HBC menu.
x Navigate to the submenu Connections and select it.
Exit the submenu Connections with the Softkey .
To (de-)activate the display configuration:
Note:
Additional software is required for this function.
You are in the submenu Connections.
1. Navigate to the menu item Display configuration and select it.
2. To access the display configuration, enter your PIN by turning and pressing the radiomatic
®
iCON.
Note:
The factory PIN is
149. To change the PIN, refer to the section Manage PIN in the chapter
Safety
functions.
To change the RF connection:
You are in the submenu Connections.
1. Navigate to the menu item RF connection and select it.
2. To access the configuration of the RF interface, enter your PIN by turning and pressing the
radiomatic
®
iCON.
Note:
The factory PIN is
149. To change the PIN, refer to the section Manage PIN in the chapter
Safety
functions.
3. Navigate to the currently set interface and select it.
Caution:
Before changing the preset RF interface, ensure that your receiver supports another RF interface
because otherwise no radio connection can be established.
4. If needed, select another RF interface from the list.
5. Confirm your selection with the Softkey .
Exit the menu item RF connection with the Softkey .