HBC-Radiomatic technos A - Troubleshooting Guide

33 / 34
Troubleshooting
Note:
Please check the functions using the cabin or cable controls first!
Problem Possible Cause Remedy
Transmitter does not react when
switched on.
 No power.
 Check battery contacts for
damage or contamination.
 Insert a fully charged
battery into the battery
compartment.
 Recharge battery.
Low-power indication after
minimal operating time.
 Battery contacts are
contaminated or damaged.
 Battery not charged.
 Battery defective.
 Check battery contacts for
damage or contamination.
 Recharge battery.
 Ensure that recharging
process runs correctly.

Check transmitter functions
using a fully charged or
replacement battery.
The display in the transmitter
illuminates but it is not possible
to effect control commands
.
 Receiver has no voltage.
 No radio communication.
 Check the connecting cable
to the receiver.

Check the functions via the
LEDs in the radio status
panel of the receiver.
Some commands are not carried
out.
 Receiver defective.

Interruption in the connecting
cable to the machine.
 Check if all connecting
cables and cable junctions
are tight.
If none of the measures mentioned resolve the problem, then please contact your service technicia n,
dealer or HBC-radiomatic.