6
PME-MP55
HBM A0563-5.5 en
Working safely
Error messages should only be acknowledged if the cause of the error is re-
moved and no further danger exists.
The instrument complies with the safety requirements of DIN EN 61010,
Part 1 (VDE 0411, Part 1).
To ensure adequate immunity from interference, use only Greenline shielded
ducting (place the shield of the transducer cable onto the connector housing).
The MP55 module must be operated with an extra-low safe voltage (supply
voltage 18 to 30 V DC).
Conversions and modifications
The MP55 module must not be modified from the design or safety engineering
point of view except with our express agreement. Any modification shall ex-
clude all liability on our part for any damage resulting therefrom.
In particular, any repair or soldering work on motherboards is prohibited.
When exchanging any modules, only original HBM parts must be used.
Qualified personnel
This instrument is only to be installed and used by qualified personnel strictly
in accordance with the technical data and with the safety rules and regulations
which follow. It is also essential to comply with the appropriate legal and
safety regulations for the application concerned during use. The same applies
to the use of accessories.
Qualified personnel means persons entrusted with the installation, assembly,
commissioning and operation of the product who possess the appropriate
qualifications for their function.
Maintenance and repair work on an open device with the power on must only
be carried out by trained personnel who are aware of the dangers involved.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
