39PME-MP60/MP07
A0616-13.4 en HBM
6 Declaring the significant parameters
Group Parameters Meaning
DIA−
LOGUE
Password Specifying (changing) a password, 0000 - 9999
(Factory preset password: 0000)
PassStat Define password status:
active=password must be entered;
inactive=PME can be operated without a password
I.ParaS to
I.AddFnc
Access to group via keyboard free or locked.
PARAM.
SET
Load ? You can either load the factory settings or one of the four
stored parameter sets.
Save ? All device settings can be saved in four parameter sets and
will be unaffected by a power failure. Every time you switch
from Setup to Measuring mode, you are asked whether or not
the change is to be saved. The data is backed up permanently
if you confirm the query with ”Yes” on quitting Setup mode.
To Next Page
Loading...
