HBM MX1601B - Synchronization

Introduction
26 I3031-14.0 HBM: public Quantum
X
The maximum isochronous data rate per channel is ap
prox. 5 kS/sec (125 μs clock pulse on the FireWire bus).
Scaling
QuantumX supports the following types of scaling:
S Two points (2‐point / y=mx+b)
S Table (multi-point) supported from MX840B, MX440B,
MX1609/KB/TB, MX809B
S Polynomial, supported from MX840B, MX440B,
MX440B, MX430B, MX238B
The 16-channel modules (MX1601B and MX1615B) as
well as modules MX410B and MX460B only support two-
point scaling.
4.5 Synchronization
If measurement signals need to be referenced over time
with each other for processing and analysis, they must
be recorded synchronously.
All QuantumX modules can be synchronized among
themselves. This ensures simultaneous measurement on
all channels. All the analog-digital converter rates, meas
uring rates and bridge excitation voltages are therefore
also synchronized.
Synchronization methods:
Synchronisation via Ethernet IEEE1588:2008 (PTPv2)
When modules, for example, MX840B are set to this syn
chronization mode and z.B. untereinander mit einem
PTP-fähigen Switch connected using a switch with PTP
capability, they automatically synchronize with each other