13
CMD600
A2820−1.1 en
• 4 x UINT8: Subnet Mask
• 4 x UINT8: Tcpip router address
• Uint16: configuration mode (fixed or DHCP = 0x0001 = 0x0002)
• 4 x UINT8: UDP port for real−time data
Binary coding of binary data: ie, Little Endian Intel
After reception of scan packets the PC(scan device) can change network
parameters if they are not suitable for particular network with writing back:
Service ”network configuration write”. The receiver detects correct packet with
checking MAC address in header. Received settings are saved and the replay
is sent:
Data Range:
• version of the data range for UDP network configurations: starting with 1
• (new) address Tcpip
• (new) port number Tcpip
• (new) Subnet Mask
• (new) router Tcpip Address
• (new) configuration mode (fixed or DHCP)
• (new) UDP port for real−time data
Binary coding as before.
• To enable the new settings to take effect, the component at this point to
carry out a restart, which is explicitly via service method can be triggered.
Possibly. existing TCP connections will be terminated. Service: ”Restart” is
+ response.
To Next Page
Loading...
