HBM PACEline CMD600 - Debug Commands; Dac_Out_Offset; Gain_Limit

37
CMD600
A2820−1.1 en
7 Debug commands
CH_DAC_OUT_OFFSET
Used to set output offset voltage for preselected channel when signal from charge
integrator is not connected to output stage.
CH_DAC_OUT_OFFSET voltage
parameters:
voltage float Offset voltage in V.
response OK, CH_ DAC_OUT_OFFSET = voltage
parameters:
voltage float Offset voltage in V
help CH_DAC_OUT_OFFSET?
response OK, CH_DAC_OUT_OFFSET voltage [V]
CH_GAIN_LIMIT
Limit the amplifier gain (ch_gain).
command CH_GAIN_ LIMIT_ select_gain,gain
parameters:
select_gain int 0..set minimum gain of amplifier[V/C]
1..set maximum gain of amplifier[V/C]
gain float requested gain
response OK, CH_GAIN_ LIMIT = select_gain,gain
parameters:
select_gain int See description above
actual_gain float Actual gain of amplifier.
inquiry CH_GAIN_ LIMIT = ?
response OK, CH_GAIN_ LIMIT = min_gain, max_gain
parameters:
min_gain float minimum gain of amplifier[V/C]
max_gain float maximum gain of amplifier[V/C]
help CH_GAIN_ LIMIT?
response OK, CH_GAIN_ LIMIT select_gain,gain[V/C]