45
CMD600
A2820−1.1 en
Num-
ber
Protect-
ion
Glo-
bal
Default value Description
27 N N 0 Limit switch 1 threshold [EnUn]
28 N N 0 Limit switch 1 polarity.
0..active if output
1 > threshold 1.. active if output 1 <
threshold
29 N N 0 Limit switch 1 hysteresis [EnUn]
30 N N 0 Limit switch 2 threshold [EnUn]
31 N N 0 Limit switch 2 polarity.
0..active if output 2 > threshold
1.. active if output 2 < threshold
Limit switch 2 hysteresis [EnUn]
32 N N 0 Limit switch 2 hysteresis [EnUn]
33 N N 1.0000E+00 Data stream rate [Hz] (min = 1, max =
1000)
34 N N 2 DHCP mode(1..disable, 2..enable)
35 N N 192.168.1.1 IP address
36 N N 23 Telnet port
37 N N 255.255.0.0 Subnet mode
38 N N 192.168.1.0 IP gateway
39 Y Y 00:04:0E:F8:09:F6 Ethernet address (MAC)
40 N N 0.0.0.0 Data stream target
41 N N 12345 UDP port
42 N N 1 Auto scale allow (0..disable,1..enable)
43 N N 1.0000E+00 Overload reserve [V]
44 Y Y HBM Manufacturer
45 Y Y CMD600 Device type
46 Y Y 0000 Serial number
47 N N New amplifier Nb 0000 Device name
48 N N 60000 Connection timeout in ms
49 Y Y 20 Input offset slow HPF
50 Y Y −300 Input offset fast HPF
51 Y Y 5.0000e−4 HPF and LPF on k koef
52 Y Y 1.1538e−1 HPF and LPF on n koef
53 N N 0 Reset compensation disable
(0..compensation enabled,
1..comp.disabled)
54 N N 0 Reset polarity
(0..logica high level on Reset pin(on
system connector) is reset,
1...logical low on Reset pin is reset)
55 N Y 0 Address of packet of parameters.
To Next Page
Loading...
