34
6.12 USING SD CARD AND USB PORT
To launch the created .gcode le on the printer, save it to your device memory card. There are two options for transferring the le on
the printer SD card:
1. Remove the SD card from the device and put it in a SD card reader of your computer and then copy the le directly to the card.
2.
3. Connect your computer by USB cable to the printer and copy the le to the SD card without removing it from the device.
Device USB port is located on its left panel (see the “Device Description” chapter), USB cable is included. Once the device is
connected to the computer, it should be detected by the computer as a mass storage device.
To Next Page
Loading...