25
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
10 Preparing Workplace and Welding Process
10 Preparing Workplace and Welding Process
Danger from fumes and airborne particulates
Switch on the welding fume extractor at the workplace.
Ensure that the room is well ventilated.
Never weld in rooms with a ceiling height of less than 3 m.
Observe furthermore your working instructions and the accident preven-
tion regulations.
This will help to avoid health damage due to fumes and airborne particu-
lates.
Danger from re and explosion
Remove all inammable materials and liquids from your working area.
Ensure that there are no explosive materials in your working area.
Ensure that an approved re extinguisher is available at the workplace.
Danger from tripping and falling
Lay cables and connecting leads in such a way that they are protected
against damage and
that you or third parties cannot trip over them or fall.
Warning of weld spatter
Ensure that there is no equipment or apparatus in the working area that
could be damaged by weld spatter.
Remove if necessary.
To Next Page
Loading...
