47
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
13 Checking the Quality of the Weld
13.3 Optimisation of Welding Parameters
As rst step, conduct the tests outlined under points 13.1 and 13.2.
As second step optimise the welding parameters according to the table
under point 12.2 Determining the Charging Voltage.
Optimise the welding parameters of the stud welding unit.
Check the settings of the welding gun.
If necessary re-adjust the lift and spring pressure.
Refer here to the operating manual of your welding gun.
To Next Page
Loading...
