HBS CDi 1502 - Maintenance and Care; Cleaning Procedures and Safety

53
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
16 Maintenance and Care
16 Maintenance and Care
Electric shock hazard
 Always switch off the stud welding unit before starting maintenance and
care work.
 Pull out the mains plug.
Danger from insufciently qualied operating personnel
 Carry out only the work described here on your stud welding unit.
 Repairs may only be carried out by appropriately qualied personnel.
 Inform your dealer or your maintenance department.
16.1 Cleaning
 Clean the surface of the stud welding unit with a slightly damp cloth, when
necessary.
 Add a little household detergent to the cleaning water.
 Do not use solvents for cleaning.
These can damage the surface of your stud welding unit.
The inside of the stud welding unit must be cleaned at least every
three months.
 Inform your dealer or your maintenance department.