27
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
10 Preparing Workplace and Welding Process
10.2 Checking the Stud Welding Gun
Always check the operating manual of your stud welding gun to see whether it
may be used with this stud welding unit.
This stud welding unit can only be used with the HBS stud welding guns C 08,
CA 08, CI 03 and PAH-1.
Check the chuck of your stud welding gun for proper t and ensure it is tightened.
Check the bellows of your stud welding gun for damage.
Check if spring force and lift are set according to the welding parameter table in
the operating manual of the stud welding gun.
Refer here to the operating manual of your welding gun.
10.3 Checking the Automatic Stud Feeder
Always check the operating manual of your automatic stud feeder to see whether
it may be used with this stud welding unit.
This stud welding unit can only be used with the fully automatic stud feeder VBZ-3.
Refer here to the operating manual of your automatic stud feeder.
To Next Page
Loading...
