43
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
12 Welding
Use only welding elements of one batch.
Pay strict attention not to mix welding elements from different batches.
Carry out test welds again after a batch change.
Even the slightest changes to the geometry, in particular to the tip of the
welding elements require different settings for the welding process.
Now check the quality of the welded joint before inserting a new welding
element and repeating the welding process.
Work in accordance with the following point 13.
To Next Page
Loading...
