• Dangers caused by impossibility to stop the machine in best conditions, relate to solidity of the
handle and placing of engine shut down device.
• Dangers caused by defect of machine control system, relate to solidity of the handle, placing
of drivers and marking.
• Dangers caused by tearing (of the chain) during running.
• Dangers caused by shooting up of subjects or splashing of liquids.
UNPACKING
• Carefully remove the product from the box.
• Carefully inspect all parts. If any part is damaged or missing, contact your dealer or authorized
service center.
• Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
• Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger. Do not let children play with plastic bags, foils or small
parts. There is a danger of swallowing or suffocating!
• Disposal must be made in accordance with the regulations in force in the country in which the
equipment was installed.
• Make sure that bags and containers of plastic material are left strewn freely in the environment
because they pollute it.
• If you have any doubt do not use the machine, but have it checked by an authorized service
center.
• The machine is shipped partially dismantled and packaged in a metal crate to protect it during
transport. The packaged machine will appear as in fig. 3.
• Remove the crews and nuts connecting the upper crate to the base.
• Operation to be performed by two people. Lift the upper iron crate so as to free the machine
(see fig. 3).
• Free the machine from the metal fasteners securing the 4 wheels to the base.
CAUTION! To prevent damaging the blade deck and blade, move these to maximum
height during the downward movement of the base platform. Be very careful
when performing this delicate unpacking operation.
PACKAGE CONTENTS
1x body of tractor, 1x seat, 1x grass catcher, 1x steering wheel, 1x lever, 1x set of fasteners, 1x
battery, 1x charger, 1x syringe, 1x instruction manual
ASSEMBLY
For storage and transport purposes, some components of the machine are not installed in the
factory and have to be assembled after unpacking.
Unpacking and completing the assembly should be done on a flat and stable surface, with
enough space for machine handling and its packaging, always making use of suitable equipment.
Follow the instructions below.
To Next Page
Loading...
