Motor with
manual start will
not start
earth connections of the micros
witches disconnected
check connections
you are not ready for starting
check that the conditions allowing the start
are met
faulty fuel supply
check the level in the tank
check the throttle lever adjustment
check fuel filter and wiring of the fuel
faulty ignition
check that spark plug caps are firmly fitted
check that the electrodes are clean and have
the correct gap
Manually started
engine stops
earth connections of the micros
witches disconnected
check connections
Starting is
difficult or the
engine runs
erratically
fault in carburetion
clean or replace the air filter
flush out the float chamber
empty fuel tank and refill with fresh fuel
check and, if necessary, replace fuel filter
Weak engine
performance
during cutting
forward speed too high in relation to
cutting height
reduce the forward speed and / or raise the
cutting deck
Engine stops
when blade is
engaged
you are not ready to engage the blade check that the safety requirements are met
Unusual
vibrations while
working
blade unbalanced contact an authorized service
blade loose contact an authorized service
fixing bolts loose
check and tighten all the fixing bolts of the
engine and frame
Uncertain or
ineffective
braking
the brake is not adjusted correctly contact an authorized service
CAUTION! Faults which can not be rectified with the aid of this table may be
rectified by a authorized service centre.
WARNING! Do not take on complicated repair work if you don't have the necessary
equipment or the technical knowledge. The warranty is automatically voided and
the manufacturer is not held responsible if repairs are done badly.
STORAGE
CAUTION! The engine must have completely cooled down before storing the
machine.
• Never store the equipment with petrol in the tank inside a building where fumes can reach an
open flame or spark.
• Allow the engine to cool before storing in any enclosure.
To Next Page
Loading...
