CAUTION The pedal must be released gradually as sudden engagement may cause
tipping up and loss of control of the vehicle.
5. To change gear, the clutch must always be used by pushing the pedal.
WARNING! Do not suddenly release the pedal and do not start moving with the
higher gear. It may cause tipping up and loss of control of the vehicle.
BRAKING
1. First slow down the machine by reducing the engine speed.
2. Push the pedal right down to lower the speed even more until the machine stops.
3. Move the speed gear shift to idle «N» to permit gradual motion.
REVERSE
IMPORTANT! Reverse must be engaged only when the machine has stopped
moving.
1. Push the brake pedal right down.
2.
When the machine has stopped, put it in reverse by moving the lever sideways to position «R».
3. Gradually release the pedal to engage the clutch and then begin moving in reverse.
GRASS CUTTING
IMPORTANT! The machine is not designed for heavy duty use or for mowing large
quantities of grass.
The blade is engaged by means of a clutch device. To avoid damage or premature
wear of the friction elements, strictly observe the following instructions.
DANGER - : Do not touch the rotating blades. The blades are sharp, risk of serious
injury. Wait for the blade and all the moving parts come to a halt before touching
them. The blade will continue turning for some time after switching off the engine
or disabling the blade control.
• Clear lawn of debris. Be sure that the lawn is clear of stones, sticks, wire or other foreign objects
which could be accidentally thrown out by the mower or wrapped around the rotating parts.
It may cause serious personal injury to the operator and others as well as damage to property
and surrounding objects.
• Check that the grass-catcher is fitted properly.
• Move the throttle to «FAST».
• Bring the cutting deck to the highest position before engaging the blade.
• Avoid engaging the blade on stony ground or when the grass is very high.
• On particularly rought surfaces, work with greater cutting height to prevent the blade knocking
against any surface irregularities, with the resulting damage to the blade and mechanical parts.
• Disengage the blade and move the deck to max height position every time an obstacle or hump
ha to be overcome.
• When adjusting the cutting height and machine speed, be careful not to overstress the machine.
• For problem-free use, the cutting height and the movement speed must be adapted to the
height and density of the grass to be cut
• In case of blockages and drops in engine speed engage a lower gear and further raise the blade deck.
To Next Page
Loading...
