Mounting Originals 5
TANGO / TANGO XL – Operation 5–7
■ Remove the excess oil, and stick down
the transparency on all sides using adhe-
sive tape.
■ Clean the upper face of the transparency.
■ Check whether the oil is distributed
evenly under the transparency. If this is
not the case then repeat the operation.
0 Useful Tips
■ Adhesive strips as hinges
The adhesive strip at the top of the trans-
parency should not be much longer than
the transparency itself, so that the strip can
be used as a hinge when lifting the trans-
parency.
Stick the adhesive strips to all sides to seal
up the original including the punched holes,
so that oil is not spun out during rotation.
To do this, use a special adhesive tape avail-
able from:
Tesafilm,
Type 4113, 19 mm wide,
Tesa, Beiersdorf AG, Hamburg
Original
Adhesive strips
To Next Page
Loading...
