Service and Maintenance 6
TANGO / TANGO XL – Operation 6–15
8 Mounting the Alignment
Strip for Reflection Scanning
This process is only necessary if the
alignment strip is dirty or defective. The
scanning drums have the strip pre-mounted
on delivery.
The alignment strips are included in the
scope of delivery.
Before you fit a new strip, first remove all
the remains of the old adhesive strip. The
drum must be completely clean and grease-
free.
The strip is applied to the inside, parallel to
the groove in the direction of feed.
Prefabricated strips are available for this,
which are included in the scope of delivery.
Between the grooves there is a gap of
approx. 1 cm as an alignment track for
transparency scanning. Make sure that the
strip begins 5 mm from the flange end of
the drum with a field for focus
measurement. The distance to the open
drum end can vary (the 212-mm drum is
longer than the 150-mm drum).
■ Make sure that the alignment track for
the transparency mode remains free.
These mounting instructions apply for all
TANGO drums, namely both for standard
drums and for Copix drums with 150-mm
and 212-mm diameters.
2
To Next Page
