5 Mounting Originals
5–10 Edition October 1998
■ Attach the original using the upper adhe-
sive strip parallel to the drum groove (do
not cover over the alignment tracks).
■ By applying even pressure with a soft
cloth or using the pressure roller of the
mounting device, stretch the original
over the scanning drum. Continue to a
point beyond the end of the original until
the bottom adhesive strip adheres to the
scanning drum and the original is
secured.
■ Clean the upper face of the transparency.
0 Transparency Mounting using Film
Several transparencies are to be mounted
onto the scanning drum - with or without
specifying the angle - using oil, gel or other
suitable liquids and with the aid of a suit-
able mounting film (e.g. mounting film Chr-
onar-Clean-Film C 42).
■ Clean the transparencies and the scan-
ning drum.
■ Cut out the unevenness caused by the
drying hooks, if necessary or file it off.
■ Fix the film on an light table, either at the
edge of the glass plate or at the upper
edge.
■ Transfer the reference line from the light
table using a ruler and film marker onto
the upper edge of the film.
■ Arrange the transparencies wrong-read-
ing according to the reference lines or
marks onto the film, and attach them
using short adhesive strips at the upper
edge.
To Next Page
Loading...
Need help?
General
