Mounting Originals 5
TANGO / TANGO XL – Operation 5–9
0 Transparency Mounting from 6 x 9 cm
Format onwards
If the transparencies have drying hooks and
cutting out the unevenness these cause is
not permitted by the customer, fixing with
oil is not possible. If the unevenness is well
outside the image section, then fixing with
oil and foil is possible (see Transparency
Mounting using Film).
To avoid Newton rings you can treat trans-
parency originals with anti-Newton spray
(enlargement factor less than 500%) or with
scan gel (enlargement factor greater than
500%).
■ Clean the transparency and the scanning
drum.
■ If necessary, cut out the unevenness
caused by the drying hooks.
■ Attach an adhesive strip to each of the
original edges which are to be at the top
and the bottom of the scanning drum.
■ Spray the underside of the original with
anti-Newton spray, e.g. Alron spray (you
must observe the drying time of approx. 1
minute).
50 cm
20 inch
Underside of original
Hold original at a slant
Anti-Newton spray
To Next Page
Loading...
