ATTENTION!
Never pack products that can be damaged by vacuum
Never pack living animals
Warranty and/or liability expires if any damage is caused by repairs and/or
modifications that are not authorized by the supplier or any of its distributors
In case of malfunction, contact the supplier
High pressure cleaning is not allowed. This can cause damage to the electronics
and other components
Prevent water from entering the ventilation inlet of the chamber or through the
vent of the pump. This causes irreversible damage to the pump
The work space around the machine must be safe. The owner of the machine
must take the necessary precautions to operate the machine safely
It is forbidden to start the machine in an explosive environment
The machine was designed in such a way that production is safe under normal
ambient conditions
The owner of the machine must check that the instructions in this manual are
monitored effectively
The securing devices must not be removed
The correct operation and safety of the system can only be guaranteed when the
maintenance is performed correctly and on time, as prescribed
If work on the machine must be carried out, it must be disconnected and blocked
from the power supply
The housing of the machine may be hot after usage
DANGER
Only authorized persons, designated by the owner, may perform work on the
electrical installation
Ensure, by means of internal procedures and monitoring, that all relevant power
supplies are disconnected, to avoid electrical shock
The machine should not be used during cleaning, inspection, repair and
maintenance and must be disconnected from the power supply using the plug
Never perform welding work on the machine without disconnecting the cable
connection to the electrical components first
Never use the power supply of the control unit to connect to other machines
All electrical connections must be connected to the terminal strip according to
the wiring diagram
The machine should always be connected to a proper grounded outlet
To Next Page
Loading...
