Henry Schein Urispec Plus - Installing Batteries (Optional); Instrument Self-Test Procedure; Automatic Calibration

User manual Urispec
®
Plus
14
Manual Urispec
®
Plus V2.01 HS USA / 04-19
Pic. 9: Printer C Pic. 10: Printer D
Unroll the paper roll by 5 cm and place the roll in the paper compartment with
the end on the lower side. Fix the end of the paper to the housing with your
forenger while closing the ap (Pic. 9).
3.6. How to install batteries (optional)
The Urispec
®
Plus can be operated with 6 type AA batteries independent of the
mains supply. The battery compartment is on the underside of the equipment.
Notice the designated polarity (+/-) marked on the battery compartment while
inserting the batteries.
Pic. 11: Battery compartment
3.6.1. Instrument self test
The Urispec
®
Plus will perform an automatic self test each time it is turned on.
If an error message appears, the instrument will not start measurements. In this
case, please contact your local service provider.
3.6.2. Calibration
The Urispec
®
Plus will perform an automatic calibration each time a test is run.