User manual Urispec
®
Plus
39
Manual Urispec
®
Plus V2.01 HS USA / 04-19
15. Error Messages and Fault Clearance
Messages are displayed in plaintext and are self-explanatory.
Error Message /
Error Cause Solution
"Dry Strip" The test strip wasn’t dipped
completely
Repeat measurement with
a new strip
"Wrong Strip" A wrong test strip has been
detected (wrong type)
Make sure you selected
the correct strip (see 5.1.
Select strip, page 19)
"Wrong Position" The strip hasn’t been pushed
into the strip retainer far
enough
New measurement, place
strip in right position
"No Paper" Paper roll empty or printer ap
open
Replace paper and close
printer ap
"Battery Low" Batteries are low Exchange batteries or use
power pack
Instrument
doesn’t start
Power supply not installed or
defect
Check whether all connec-
tions are plugged in and
whether the power socket
is functioning
In case an error cannot be cleared using the instructions above, please contact
the Henry Schein Pro Repair Service (see 17. Service, page 41).
To Next Page
Loading...
