HERMOS AG
Gartenstraße 19 • 95490 Mistelgau
Phone: +49 9279 991 - 0
E-mail: rfid@hermos.com
back to the table of contents
The checksum is not necessary when using the TCP/IP interface (No
transmission). The end character is only transmitted.
If the device is operated in ASC-W1 mode, the complete end packet is
transmitted (end character and 4 bytes checksum).
10.3 Data elements
The data elements that are used by default ASCII messages, which are described in the
message details section, are defined in this section.
The tuning value is a set value for the optimal antenna tuning. For optimum read and write
ranges, the value is automatically determined by the reader. The value is measured in 16
steps (0-F). He can also be targeted.
Example:
Command of the message, see table in Chapter “Commands“.
The data is represented in HEX format by 2 ASCII characters. The data always includes
every 8 bytes of the corresponding page of the transporter.
Example:
Transponder data in ASCII-Format „12345678“ (8 bytes)
Transponder data in HEX-Format 0x31 0x32 0x33 0x34 0x35 0x36 0x37 0x38
Data in message „3132333435363738“ (16 ASCII-characters)
automatic tuning from the reader
To Next Page
Loading...