HERMOS AG
Gartenstraße 19 • 95490 Mistelgau
Phone: +49 9279 991 - 0
E-mail: rfid@hermos.com
back to the table of contents
10.4.7 N – Reset
The command N performs a reset of the hardware/software of the reader.
After performing the reset operation, the device sends a confirmation message.
After a hardware reset, a confirmation („n0“) is sent to the host.
If TCP / IP is used as the interface, the host will not receive an acknowledgment,
because an existing TCP/IP connection is interrupted by the reset.
To Next Page
Loading...